Hinkley Lighting MORGAN 4876BR - Manual

assembly instructions
Family: Morgan Item No. 4876
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the fixture shade.
start here
487
6
Drawing 1 - Assembly
Drawing 2 - Glass Installation
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
06.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
3
2
1
4
5
H
S
1. To assembly main body of fixture prior to hanging, first rotate arms (A) attached to
main body (M), until they are equally spaced 60 degrees apart, see - Drawing 1 and 2.
2. Next take Ring (R) and slip stud (D), located in the back of arms (A), throught the
holes in ring (R).
3. Next thread on barrel knob (K) onto end of exposed stud (D) to secure ring to
arms (A).
4. Fixture is ready for installation, please following mounting instruction sheet
(IS-19) provided. After fixture is installed please return to this section for
instructions to complete assembly.
1. Prior to installing the candle sleeves and shaded, attached chained crystal (C) to
hook located directly under the loop at the top of fixture.
2. To install shade first slip candle sleeve with harp (2) over socket (1) - see Drawing 2.
3. Fixture should be lamped accordingly at this time.
4. Align center hole in shade mount (S) with hole in the harp (H).
5. Thread stud (4) into hole in harp (H) approximately 1/4”.
6. Thread barrel knob (5) onto end of exposed stud (4) and tighten to secure shade.
R
K
D
C
A
M
A A
A
A A
A
60 degrees
apart