Hinkley Lighting DUET 5615 - Manual

assembly instructions
Family: Duet Item No. 5612/5613/5614/5615
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections, assem-
bling the main body of the fixture, mounting the fixture to the wall,
and then installing the glass.
star t here
5615
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 3 - Glass installation
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this fixture.
5
1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see Drawing 1.
2. Attach the back plate (B) to the mounting plate (A) using the screws (C).
01.01.12
5612
to
Drawing 4 - Glass installation
Drawing 2 - Bulb shield installation
3 4
4
a
2 4
4 1
b
1. To install glass first remove decorative cab (1), threaded tube (2), spacer (3), and plastice washers
(4) from arm (A) that extends from backplate (B) - see Drawing 3.
2. First slip a plastic washer onto each of the threaded tubes (c), now slip glass (5) [large piece] onto
threaded tubes (C), followed by plastic washers (4).
3. Thread spacer (3) onto threaded tube (C) and hand tighten only, now thread threaded tube (2)
into end of spacer (3) - see Drawings 3 and 4
4. Now slip a plastic washer onto threaded tube (2), then slip glass (6) [small piece] onto threaded
tubes (2) - see Drawing 4
5. Slip a plastic washer (4) onto threaded tubes (2), then thread decorative knob (1) onto end of
threaded tube (2) and hand tighten only.
6
1. Fixture can be lamped accordingly prior to glasss installation. First slip G-9 bulbs provided into
socket.
2. Then thread bulb shield (BS) onto socket (S).
G-9 bulb
c
BS S
a e f
d
b
c
g
1. Remove ball knobs (c) from front of backplate (d)- see Drawing 1.
2. Remove retainer plate (a) from backplate (d).
3. Attach retainer plate (a) to junction box using two 8-32 screws (b).
4.Additional screws can be installed at points (e) for additional mounting support .
Please use appropriate anchors.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com