Hinkley Lighting CORDILLERA 4095RI - Manual

assembly instructions
Family: Cordillera Item No. 4095 RI
start here
4095
Drawing 1 - Glass Installation
Drawing 3 - Glass Installation
3
4
5
A
B
1 A
12.29.08
paper towels or
thin rag strips
6
7
1
1
12
*** The construction of this fixture will be accomplished by first assembling main
body, making all necessary electrical connections, hanging the fixture and then
installing the fixture glass.
3
C
Drawing 2 - Arm Rotation
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Thread loop (1) onto nipple (2) - see Drawing 3.
2. Rotate arms (C) by grasping the top and bottom, until they are 72 degrees apart
and vertically straight - see Drawing 2.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer to I.S. 19 Instruction sheet to hang fixture.
1. Fixture can now be lamped accordingly.
2. For outer glass installation, to prevent glass from being scratched or chipped
during installation, it is recommended that strips of paper towels or a thin rag be
draped over glass ring (A) - see Drawings 1 and 3.
3. Slip glass (3) through ring (A) and into glass holder (B).
4. Repeat steps 2-3 for remaining 4 pieces of outer glass.
5. To install inner glass, slip large glass cylinder (4) into center glass holder (5).
6. Slip ring (6) onto top of center glass (4).
7. Slip short top glass (7) into top of ring (6).
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com