Hinkley Lighting 40W G9 BRICK LIGHT 59040 - Manual

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com
installation instructions
Family: 120V Series Brick Light Item No. 59040/59009 BZ
1. Find a clear area in which you can work.
2. Carefully review instructions prior to assembly.
3. Gather tools required : WIRE STRIPPERS, PHILIPS HEAD SCREWDRIVER,
SILICONE GREASE, THREAD SEALANT.
• Save these instructions for future reference.
start here
59040 59009
WARNING: LUMINAIRE MUST BE INSTALLED AND GROUNDED IN ACCORDANCE
WITH THE NATIONAL ELECTRICAL CODE (NEC) AND LOCAL CODES. FAILURE TO
DO SO MAY RESULT IN SERIOUS INJURY AND/ OR DAMAGE TO THE LUMINAIRE.
FIXTURES WHICH MAY COME IN CONTACT WITH OR BE EXPOSED TO MOISTURE
(I.E. OUTDOORS) SHALL BE INSTALLED ON A GFI (GROUND FAULT INTERRUPTOR)
POTECTED CIRCUIT.
ALWAYS USE UL RECOGNIZED WIRE CONNECTORS FOR CONNECTIONS.
1. Please refer to the mounting instructions located on the back of this sheet to
continue installation of this fixture.
lamp installation replacement
1. To prevent electrical shock, disconnect from the electrical supply before servicing.
2. Remove face plate (B) by loosening 4 philips screws (C) on front of louvre - see
Drawing 1.
3. Remove electrical tray (D) by loosening 2 philips screws (E).
4. Replace lamp with correct wattage and type marked on fixture label.
CAUTION: DO NOT EXCEED MAXIMUM WATTAGE MARKED ON LUMINAIRE LABEL.
Info 59040 BZ: Lamp Type G9, Maximum Wattage is 40 watts per bulb.
Info 49009 BZ: Lamp Type G23-2, Maximum Wattage is 9 watts CFL per bulb.
Drawing 1 - Lamp Installation
B
E D
C
HINKLEY LIGHTING
WARNING: TO REDUCE THE
RISK OF FIRE, OR INJURY
TO PERSONS:
1. Turn off/unplug and allow
to cool before replacing lamp.
2. Lamps get hot quickly!
Contact only switch/plug
when turning on.
3. Do not touch hot lens,
guard or enclosure.
4. Keep lamp away from
material that may burn.
5. Do not operate luminaire
fitting with a missing
or damaged cover.