Hinkley Lighting REEF 1951 - Manual

assembly instructions
Family: Reef Item No. 1951 HE/VZ
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To remove glass, remove four threaded studs (1) from side of fixture - see Drawing 2.
2. Lift top assembly (2) and glass (3) off the main fixture body (4).
3. Fixture can now be lamped.
4. Reassemble fixture by dropping top assembly (2) and glass (3) back onto main body
assembly (4).
5. Line up holes in uprights (A) and holes (B) in top assembly.
6. Thread in studs (1) into side of fixture.
Note: Overtightening may cause damage to glass.
*** The construction of this fixture will be accomplished by first making all
necessary electrical connections, mounting the fixture to pre-installed post, and
then removing glass to install lamp.
start here
1951
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Lamp Installation
Drawing 1 - Fixture Mounting
2
3
4
1
A
B
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post.
2.7.08
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com