Hinkley Lighting VALLEY FORGE 2075 - Manual

HINKLEY LIGHTING 33000 Pin Oak Park way Avon Lake, Ohio 44012 800 446 5539 w w w.hink leylighting.com
star t here
(page 1)
assembly instructions
2070
2
3
4
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** fixture will be accomplished by first, installing mounting hardware, making
all necessary electrical connections, mounting fixture to wall, installing the
mirror and candle sleeves, installing the glass, and then attaching the door.
Item No. 2070 / 2074 / 2075
01.01.13
2074 2075
A J
B
C D
E
Drawing 1 - Fixture Mounting
1. Prepare mounting strap (A) by threading nipple into the center hole of the mount-
ing strap (A), approximately 1/4“.- see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two screws (C) provided.
1. To mount fixture, slip center hole of backplate (E) over nipple (C) and hold fixture in
position - see Drawing 1.
2. Thread decorative knob (D) onto end of nipple (C) and tighten to secure fixture.
Drawing 2 - Glass Installation
door
frame
1. After mounting fixture to wall, install the side panels of glass (1) by sliding them
through the front door frame, and placing them between the glass clips (2) and
against the fixture frame - see Drawing 2.
2. Fold glass clips (2) up against glass to secure glass in fixture.
3. Proceed to page 2 of instruction sheets to complete fixture assembly.
1
2