Hinkley Lighting VALLEY 4708VK - Manual

assembly instructions
Family: Valley Item No. 4708 VK/BN
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main
body of the fixture, making all necessary electrical connections, hanging the fixture
from the ceiling, and then installing the glass.
start here
4708
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble main body, spread arms (A) located on the main body assembly (1), until
they are equally spaced 120 degrees apart - see Drawings 1 & 2.
2. Thread screw (2) onto top bracket of arm (A) and tighten to secure arm (A).
3. Rotate arms (B) outward until they are 60 degrees apart.
4. Please refer to the hanging instruction sheet (I.S. 19) provided to hang fixture. Then
refer back to this sheet to install glass.
1. To install glass, remove socket ring (3) from socket (C) - see Drawing 2.
2. Slip glass (4) over socket (C) and hold in position.
3. Slip spacer (3) and thread socket ring (5) onto socket (C) to secure glass (4).
4. Use socket ring tool to tighten socket ring (5). Notches in socket ring fit into notches
on socket ring tool. Tighten socket ring until snug. Do not over tighten.
5. Repeat steps 1-3 for remaining glass.
6. Fixture can now be lamped accordingly.
Drawing 1 - Assembly
Drawing 2 - Glass Installation
1
2
C
A
B
4
3
5
notches
socket ring tool
2.7.08
B
A
A
A A
A
A
B B
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com