Hinkley Lighting ROWE PARK 2131 User Manual
Start here, Assembly instructions

Drawing 2 - Fixture Mounting
A
B
1. Mount center bar / stem (2) onto top of cage (1), using the ball knobs (3).
2. Slip roof (4) onto center bar / stem (2).
3.Thread top knob (5) onto end of center bar / stem (2) and tighten.
ground
wire
assembly instructions
Family: Rowe Park Item No. 2131
21
31
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first completing the
assembly of the fixture, mounting the mounting strap to the junction box and then
mounting the fixture.
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this page to continue installation of this fixture.
10.16.09
1. Slip post fitter (A) over post. Make sure all wiring is tucked inside the post. This will
prevent and wiring from getting pinched between the inside of the post fitter and
the post.
2. Drill 3 - 1/16” diameter holes into pole, using holes in post fitter as quide.
3. Screw in the sheet metal screws (B) provided.
4
Drawing 1 - Fixture Assembly
2
1
3
4
5
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com