Hinkley Lighting CHERRY CREEK 1272 - Manual

2.7.08
H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com
assembly instructions
Family: Cherry Creek Item No. 1272
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To assemble fixture, thread loop (1) into nipple (2).
*** The construction of this fixture will be accomplished by first assembling the
the main body of the fixture, making all necessary electrical connections, and
then hanging the fixture from the ceiling.
start here
1272
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 1272 fixture is 100 watts per bulb.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer to the hanging instruction sheet (I.S. 19) provided to complete installation
of this fixture.
Drawing 1 - Fixture Assembly
3
2
24
5
2 A
26
1. To install glass , remove roof (3) from main body assembly (4), by removing knob
(5) from under roof lip.
2. To install glass, bend up glass clip (A) and slip glass (6) into main body assembly (4).
3. Bend glass clip (A) back down to secure glass (6).
4. After all glass panels are installed, replace roof (3) and thread on knobs.
5. Fixture can now be lamped accordingly.
11
12
4
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com