Hinkley Lighting MIME FR45602BNI User Manual
Mime
FR45602BNI
MIME
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first installing the mounting hardware
to the junction box, making all necessary electrical connections,mounting the
backplate to the wall and then installing the fixture glass.
SAFETY WARNING:
Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1
Prepare mounting strap (a) by threading nipple into the center hole of
the mounting strap (a), approximately 1/4“- see Drawing 1.
2
Attach mounting strap (a) to junction box (j) using two screws (b) provided.
STEP 2
Make electrical connections from supply wire to fixture lead wires.
Refer to instruction sheet (I.S. 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of this fixture.
STEP 3
1
To mount backplate to wall, slip center hole of backplate (e) over nipple (c) and
hold fixture in position - see Drawing 1.
2
Thread decorative knob (d) onto end of nipple (c) and tighten to secure fixture.
3
Fixture can now be lamped accordingly.
STEP 4
1
To install shade (1), slip mounting bar (3) behind brackets (4) on backplate (2)
- see
Drawing 2.
[DRAWING 1]
[DRAWING 2]
Bulbs:
2- 60W CAND.
Replacement Parts:
GLASS:
R45602SH, R45602CRY-A, R45602CRY-B
01.01.11
800.421.3517 WWW.FREDRICKRAMOND.COM
d
1
a
j
e
c
b
2
3
4
[DRAWING 3]
STEP 5
1 Attach short crystals (5) to the two outside loops (6) located on the bottom of the
shade (1). - see Drawing 3.
2 Attach crystal (7) to the center loop (8) located on the bottom of the shade.
3 Fixture is complete.
1
5
7
6
8