beautypg.com

Hinkley Lighting HUDSON 1911 User Manual

Start here, Assembly instructions

background image

assembly instructions

Family: Hudson Item No. 1911

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first making all necessary
electrical connections, mounting the fixture to pre-installed post and then lamping
fixture.

start here

1911

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

Drawing 1 - Fixture Mounting

Drawing 2 - Lamping Fixture

1. Fixture is mounted using 3 - 1/4-20 set screws.
2. Make all necessary electrical connections following wiring instructions below.

06.01.13

5

1

3

5

9

2

4

6

7

1. To install glass first unthread top knob (1), and slip off roof (2) - see Drawing 2.

2. Remove the three ball knobs (3) and lockwashers (4) from stud locate at the top

of each upright.

3. Slip off roof pan (5).

4. Slip small hole in bottom of glass (6) over socket (S).

5. Slip spacer (8) over socket, and then thread on socket ring (7) and tighten to

secure glass.

NOTE: fixture can be lamped accordingly at this time.

6. Follow steps 1, 2, and 3 in reverse order to re-assemble fixture.

1. To install glass first unthread top knob (1), and slip off roof (2) - see Drawing 2.

2. Remove the three ball knobs (3) and lockwashers (4) from stud locate at the top

of each upright.

3. Slip off roof pan (5).

4. Slip small hole in bottom of glass (6) over socket (S).

5. Slip spacer (8) over socket, and then thread on socket ring (7) and tighten to

secure glass.

NOTE: fixture can be lamped accordingly at this time.

6. Follow steps 1, 2, and 3 in reverse order to re-assemble fixture.

8

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1. Slip post fitter (A) over top of pre-installed post (B) - see Drawing 1.
2. Using the holes in the side of the post fitter as guides, drill three 1/16” diameter
holes in the pole.
3. Now screw in the three sheet metal screws (C) to secure fixture.