Hinkley Lighting BARRINGTON 1751 User Manual
Start here, Assembly instructions
assembly instructions
Family: Barrington Item No. 1751
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
main body of the fixture, making all necessary electrical connections, mounting
the fixture to pre-installed post, and then installing the glass.
start here
1751
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Fixture Mounting
Drawing 1 - Fixture Assembly
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped bushings in post fitter.
4. Tighten screws (C) to secure fixture to post.
1.01.12
4
2
1
3
8
9
7
5
6
1. To complete assembly of fixture, first slip candle sleeves (1) over socket (2), followed
by candle chaser (3).
2. Thread center stem (4) onto threaded tube (5) located at the top of the cluster
assembly (6).
3. Fixture can be lamped accordingly at this time.
4. Slip glass (7) over candle cluster and center stem, and seat into bottom roof.
5. Slip roof (8) onto center stem, and seat on top of the glass (7).
6. Slip knob (9) over center stem (4) and thread finial (9a) onto end of center stem (4)
to secure roof and glass. NOTE: hand tighten only.
7. Fixture is complete.
9a
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com