beautypg.com

Hinkley Lighting SOLARA 2026 User Manual

Start here, Assembly instructions

background image

assembly instructions

Family: Solara Item No. 2026

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the backplate (E).

2. Attach mounting strap (A) to junction box (J) using two 1” screws (C) provided.

1. To mount fixture, slip the two mounting screws (B) through the two mounting holes
(D) in the backplate (E) - see Drawing 1.
2. While holding fixture in place, thread the two ball knobs (F) on to the end
of the mounting screws (B), and tighten.

*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then installing the glass.

start here

2026

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Fixture Mounting

Drawing 2 - Glass Installation

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

5

A

J

B C

D

E

F

6.01.11

4

2

2A

5

2

1

22

3

1. Fixture can now be lamped accordingly.
2. To install glass remove the two screws (1) holding bottom cap (2) and top cap (2A)

3. Remove the four screws (3) two from top of body and two from bottom of body

(4) in place.

5. Slip glass (5) into fixture between the inner side walls (A). Making sure
back edge of glass is against glass clips previously installed.
6. Attach glass clips (4) from parts bag

and slip over edge of glass and align screw hole.

Using screw (3) removed earlier, thread screw back into place

to secure glass.

7. Replace bottom and top caps (2) and (2A) and thread in screws (1) to seccure.

in place.

4. Attach one set of clips (4), from parts bag, in the bottom of the fixture - see Detail
Drawing 3 for reference.

that will hold glass clips

Drawing 3 - Detail Drawing

3

25

4

Make sure clip tab
rest behind glass
edge.

2

2A