Hinkley Lighting BOLLA 4651OB-OP-LED User Manual
Star t here, Assembly instructions

assembly instructions
Family: Bolla Item No. 4651
1. Find a clear area in which you can work.
2.
3. Carefully review instructions prior to assembly.
ceiling, and then installing the glass.
star t here
465
1
1. To assembly main body slip threaded tube at top of Arm (3) through hole (D) in
canopy (C) - see Drawing 1.
2. Slip lockwasher (2) over threaded tube and thread on hex nut (1), align arm and
tighten.
Drawing 3 - Fixture Mounting
Drawing 2 - Strap Detail
B
(side view)
gull wing
bracket
B
1 2
3
4
Drawing 1 - Fixture Assembly
13
11
H
G
9
7
6
8
14
15
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Prepare gem strap (A) for mounting by threading two screws (B) provided into back
of gull wing bracket of gem strap (A) - see Drawing 2.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 2 and 3.
2. Mount gem strap (A) to junction box (J), using the two 1” screws (C).
5
2.7.08
Make electrical connections form supply wire to fixture lead wires. Refer to
instruction sheet (IS18) and follow all instructions to make all necessary wiring
connections. Then refer back to this sheet to complete installation of this fixture.
1. Prior to installing glass, fixture can now be lamped.
2. To install glass first thread hex nut (12) onto end of threaded tube (5), approx. 3/8”.
- see Drawing 1.
3. Slip steel washer (11) followed by plastic washer (12) onto threaded tube (5).
4. Slip threaded tube (5) with hex nut and washers through center hole of glass (6).
5. Slip plastic washer (13) over threaded tube (5) followed by steel washer (14) and
thread on hex nut (15) and tighten to secure.
6. Slip threaded tube (5) through center hole of arm assembly (7).
7. Thread decorative ball knob (8) onto end of threaded tube (5) to secure lower
arm assembly to glass.
8. To attach glass to fixture body by aligning holes (G) in end of arm with studs (H)
in end of arms (3). Slip studs through holes in arm and thread on ball knobs (9) to
secure glass to fixture.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com