Hinkley Lighting FLOURISH 3287SL - Manual

- 1 -
Item No. 3287
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, attaching the mounting strap to the junction box,
making all necessary electrical connections, hanging the fixture from the
ceiling, installing the shade, and then installing the glass lens.
1. Fixture can now be installed. Please follow instruction sheet IS-19-84 provided.
After installation return to this section for Glass installation instructions.
SAFETY WARNING: READ WIRING AND GROUNDING
INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.
TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW
WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR
LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Before installing Glass, the fixture can be lamped accordingly.
2. Thread the nipple (2) into the wire body.
3. Slide the shade (8) into place , and screw knobs (9) into crossbar (10)
4. Slide one flat steel washer (5) onto the nipple (2), then one rubber
washer (6), glass (7), then again with the remaining rubber washer (6), the
remaining flat steel washer (5), and thread on the Hex nut (8).
5. Slide on decorative cover (9) followed by the decorative knob (10).
start here
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Drawing 1 - Fixture Assembly
assembly instructions
3287
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com