Hinkley Lighting MIME FR45606BNI - Manual

FR45606BNI
MIME
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first assembling the main body,
installing the mounting hardware to the junction box, hanging the fixture and then
installing the shade and crystals.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1
See Drawing 1.
STEP 2 Refer to Hanging Instruction Sheet [FRIS19] to hang fixture. Then refer
back to this sheet to continue installation of this fixture.
STEP 3
1
2
[DRAWING 1]
Bulbs: 3-60W CAND. Replacement Parts: SHADE: R45606SH, R45602CRY-A
01.01.11
2
3
4
a
8
d
c
ce
5
b
1
e
7
6
Slip center ring (1) along wire and between arms (2). Line up holes in ring
to holes in arms.
Slip ball knob sutd (3) through arm and thread into ring (1).
Slip center column (4) along wire and through ring (1) and thread onto top
of main body (a).
Slip loop (5) along wire and thread onto top of fixture.
Spread arms (b) until they are 120 degrees apart.
Slip candle sleeve (5) over socket (c).
Fixture is ready for installation.
2
3
4
5
6
7
-
e
9
10
10
t
3
Take shade (7) and line up holes in tabs (d) with the holes in
end of arms (b). Shade tab shold be on top of the arm.
Slip ball knob stud (8) throgh hole in arm and thread it into shade
tab. Repeat process with the remaining arms.
Thread finial (9) onto threaded tube (t) at bottom of fixture.
Attach crystals (10) at areas (e) indicated. 4