beautypg.com

Hinkley Lighting KEY WEST 1613RB User Manual

Start here, Assembly instructions

background image

assembly instructions

Family: Key West Item No. 1613 RB

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the glass.

start here

16

13

1. To install glass, thread nipple (2), located in the center of pan (1), into coupler (9)
approximately 1/4” - see Drawing 1.
2. Tighten hex nut (10) up against coupler (9) to lock nipple (2) in place.
3. Fixture can now be lamped.
4. Slip glass (3) into cage (4)and hold in position.

5. Slip cage (4) and glass (3) over nipple (2) and hold in position.
6. Thread knurl nut (5) onto nipple (2) and tighten against cage assembly.
7. Slip cap (6) followed by bottom cap (7) onto nipple (2) and hold in position.
8. Thread on bottom knob (8) and tighten.

Drawing 3 - Fixture Mounting

Drawing 2 - Strap Detail

B

(side view)

gull wing

bracket

glass

B

Drawing 1 - Fixture Assembly

1

3

4

5
6
7

2

10

9

8

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this page to continue installation of this fixture.

1. Prepare gem strap (A) for mounting by threading two screws (B) provided into
back of gull wing bracket of gem strap (A) - see Drawing 2.
Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 2 and 3.
2. Mount gem strap (A) to junction box (J), using the two 1” screws (C) provided.

1. To mount fixture, slip the two mounting screws (B) through the two mounting
holes (D) in the ceiling pan (E) - see Drawing 3.
2. While holding fixture in place, thread the two ball knobs (F) onto mounting screw
(B) and tighten.

4

5

2.7.08

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com