beautypg.com

Hinkley Lighting TRELLIS 1437 User Manual

Start here, Assembly instructions

background image




















































































____

Assembly Instructions

____

Item No. 1437

start here

---

1. Find a clear area in which you can work.
2. Unpack Fixture and glass from carton.
3. Carefully Review Instructions Prior to assembly.

***

The construction of this fixture will be accomplished by first assembling the

main body of the fixture, installing the glass, attaching the mounting strap to
the junction box, making all necessary electrical connections, mounting the
fixture to the pier.

Drawing 4 – Fixture Installation

1. To install mounting bracket (M), determine location where mounting bracket is
to be attached and mark hole location. - see Drawing 1.
2. Make sure mounting bracket is installed so fixture is position correctly when
installed.
3. NOTE: It is up to customer to supply appropriate fasteners for attaching
mounting bracket.

SAFETY WARNING: READ WIRING AND GROUNDING
INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.
TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW
WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR
LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1. To install glass it is necessary to first remove the decorative knob (6), then the roof
(1) from the fixture cage (2). - see Drawing 2.
2. This is accomplished by lifting the roof off of the threaded nipple (3) from the top
of the fixture.

Drawing 1 – Fixture Mounting

1. To install glass, slip glass panel (4) through top of cage (2) - see Drawing 3.
2. Position glass (4) between glass clips (5) and fold over clips to secure glass in
fixture cage.
3. Fixture can be installed at this time.

Drawing 3 – Glass Installation

Drawing 2 – Glass Installation

Make electrical connections from supply wire to fixture lead wires.
Refer to instruction sheet (I.S. 18) and follow all instructions to make
all necessary wiring connections. Then refer back to this sheet to
continue installation of this fixture.

1. To mount fixture slip base (A) over previously installed mounting bracket (M),
making sure to line up screw sleeves (C) in base with threaded knobs (B) in
mounting bracket (M), make sure no wires are pinched after slipping base over
mounting bracket - see Drawing 4.
2. Make sure the threaded knobs (B) are tightened to secure the fixture.
3. Fixture can be lamped accordingly at this time.
4. Replace roof (1) and slide over the threaded nipple (3) and finish reassembly by
threading the decorative knob (6) back onto the threaded nipple.
5. Fixture is complete and power can be restored.

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com