Hinkley Lighting GRAYSON 2034 - Manual

assembly instructions
Family: Grayson Item No. 2030/2034
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then installing the glass.
star t here
2034
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 2030/2034 fixture is 100 watts per bulb.
Drawing 1 - Fixture Mounting
Drawing 2 - Glass Installation
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this fixture.
01.01.12
2030
A J
B
F
F1
C D
E
1. Prepare mounting strap (A) by threading threaded tube (C) into the center hole
of the mounting strap (A), approximately 1/4” - see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two short screws (C) provided.
3. Slip lock washer (F1) over nipple (C) and thread hex nut (F) onto threaded tube (C).
4. Hex nut (F) can be tightened against mounting strap (A) after adjusting threaded
tube (C) to proper mounting length.
6. Thread decorative knob (D) onto end of threaded tube (C) and tighten to secure
5. To Mount fixture to wall slip center hole of backplate (E) over the threaded tube (C)
and hold fixture in position.
fixture.
1. Prior to installing glass fixture can be lamped accordingly.
2. To install glass (2), slip into glass holder (GH).
3. Thread in retaining screws (1) into side of glass holder (GH), and tighten.
NOTE: hand tighten only.
4
4
3
2
1
1
2
GH