Hinkley Lighting MONACO 4858BC User Manual
Start here, Assembly instructions

assembly instructions
Item No. 4858
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
start here
4858
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: It will be necessary to determine the length of rods you will require to hang your
fixture at the desired height. After this has been established, please follow the
instructions below.
Drawing 1 - Assembly
Drawing 2 - Assembly
01.01.13
1. Slip first rod section (B) along wire and thread into top of main fixture body (A).
2. Slip next section of rod (C) along wire and thread into top of previously installed
rod - See Drawing 1.
3. Continue adding sections of rod until all necessary length have been attached to
the fixture.
4. Fixture can now be mounted to the ceiling by following mounting instruction sheet
(IS19-81) provided.
1. To install shade (2), remove socket ring (3) from socket.
2. Slip mounting ring (R) of shade (2) over socket (1).
3. Thread socket ring (3) back onto socket (1) to secure shade.
4. To attached crystal (4), loop ring at top of crystal through eyelet.
B
C
A
C
1
2
3
R
4
***The construction of this fixture will be accomplished by first, determining
rod lengths required, assembling the main body, making all necessary electrical
connections, hanging the fixture and then installing the shade.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com