Hinkley Lighting SPENCER 4194BN - Manual

assembly instructions
Family: Spencer Item No. 4194
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the fixture shade.
start here
4194
Drawing 1 - Assembly
Drawing 2 - Glass Installation
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble main body, spread arms (A) located on the main body assembly (1),
until they are equally spaced 90 degrees apart - see Drawing 1.
2. Slip loop (1) along wire and thread onto threaded tube (B).
3. Please refer to the hanging instruction sheet (I.S. 19) provided to hang fixture. Then
refer back to this sheet to install shade.
06.01.13
2
1
socket
tool
1. To install glass, remove socket ring (3) and spacer (2) from the socket (1) - see
Drawing 2.
2. Slip glass (4) over socket (1) followed by spacer (2).
3. Thread socket ring (3) onto socket (1) and tighten. NOTE: socket tool provided
should be used to tighten socket ring (3). Slip large end over socket ring to engage.
4. Fixture can now be lamped accordingly
3
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
90 degrees
apart
A A
A
A
A
A
A A