Hinkley Lighting FLOURISH 3281SL - Manual

____ Assembly Instructions ____
Item No. 3281
---
1. Find a clear area in which you can work.
2. Unpack Fixture and glass from carton.
3. Carefully Review Instructions Prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, attaching the mounting strap to the junction box,
making all necessary electrical connections, hanging the fixture from the
ceiling, installing the shade, and then installing the glass lens.
Drawing 2 – Glass Installation
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting
plate (B) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (1).
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip
supply wires through large center hole.
1. Before installing Glass, the fixture can be lamped accordingly.
2.
Slide nipple (3) through tube (2) and thread into wire body.
3. Slide the shade (11) into place , and screw knobs (12) into crossbar (13)
4. Slide check ring (4) onto nipple followed by one flat steel washer (5) , then
one rubber washer (6) , glass (7) , then again with the remaining rubber
washer (6) , the remaining flat steel washer (5) , and thread on the Hex nut
(8) .
5. Slide on decorative cap (9), and then thread on decorative knob (10).
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Hang the fixture by slipping the mounting holes (D) in the canopy (1) over screws (B),
mounted in strap (A) previously - see Drawing 2.
2. Thread ball knobs (E) onto end of screw (B) and tighten to secrure fixture.
J
B
A G
E C
D
01.01.13
start here
3281
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com