Hinkley Lighting HADLEY 3304BR-LED - Manual

assembly instructions
Family: Hadley Item No. 3304
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Prior to installing glass, fixture should be lamped.
2. To install glass (2), lay glass into ring (3) - see Drawing 2.
3. Slip the 3 holes (J) of ring (3) over the threaded studs (I) of the uprights (UP) and hold
in position.
4. Thread decorative knobs (4) onto end of studs (G) and tighten to secure glass.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the glass.
start here
3304
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Mounting
Drawing 2 - Glass Installation
01.01.13
2
3
4
J
UP
I
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
A
B
C
H
G D
1. Fasten mounting strap (B) to outlet box (A) with the original box screws (C) - see
Drawing 1.
2. Thread nipple (D) into mounting strap (B) approximately 3/8”.
3. Hex nuts (E) and lockwashers (F) can be used to lock threaded nipple (D)
by tightening against mounting strap (B) after adjusting nipple height.
1. Slip canopy (G) over nipple (D) and up against ceiling - see Drawing 1.
2. Thread decorative finial (H) onto end of nipple (D) and tighten to secure fixture.
E
F