beautypg.com

Hinkley Lighting TRUMAN 4024AN User Manual

Start here, Assembly instructions

background image

assembly instructions

Family: Truman Item No. 4024

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the glass.

start here

40

24

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 2 - Fixture Assembly

01.01.12

Drawing 1 - Fixture Assembly

1. Slip loop (A) along supply wire and thread onto thread tube (2A) located at the top
of the center column.
2. Rotate arms (1) attached to center column, until they are equally spaced 120
degrees apart - see Drawing 1.
3. Attach ring (2) by lining up the three holes (B) in the ring with the 3 holes (C) in
the arm (1) and threading in the flat head phillips screws (3) to secure ring - see
Drawing 2 AND 3.

1

1

Drawing 3 - Fixture Assembly

1

2

3

5

4

9

8

D

A

A2

7

6

B

C

1

2

3

10

9

11

1. Prior to installation of the glass, the fixture can be mounting to the cieling. Please
follow mounting installation instruction sheet (IS-19) provided.

3

4

NOTE: Fixture can be lamped accordingly prior to glass installation.
1. To install glass, thread tube (4) into coupler (D) approximately 3/8”, making sure
hex nut (5) on the tubing is near coupler.
2. Tighten hex nut (5) against coupler (D) to secure tube (4).
3. Slip glass (6) onto fixture and up against ring (2) and hole in position.
4. Slip rubber washer (7) followed by steel washer (8) over tube (4), and hold in
position.
5. Thread hex nut (9) onto tube (4) and tighten to secure glass (6).
6. Slip cap (10) onto tube (4), and then thread finial (11) onto end of stem (4) and
hand tighten only, to complete assembly.

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com