Hinkley Lighting ELM 1152RB User Manual
Start here, Assembly instructions

assembly instructions
Family: Elm Item No. 1152 RB
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first making all
necessary electrical connections, hanging the fixture from the ceiling, and then
installing the glass.
start here
1152
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 1152 fixture is 100 watts per bulb.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Please refer to the hanging instruction sheet (I.S. 19) provided to continue installation
of this fixture. Then refer back to this sheet to install glass.
1. Slip loop (1) along wire and thread onto threaded tubing (2) on top of fixture.
1. To install glass, grip spacer (4) and remove threaded socket ring (3) from socket (A).
Once ring (3) is removed spacer (4) will slip off socket (A).
2. Slip glass (3) over socket (A) and hold in place.
3. Slip spacer (4) over socket (A) and hold in place.
4. Thread socket ring (3) onto socket (A) and tighten.
5. Fixture can now be lamped accordingly.
Drawing 1 - Fixture Assembly
1
A
5
4
3
2
5.5.10
5
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com