Hinkley Lighting DRAKE 1992 User Manual
Start here, Assembly instructions

assembly instructions
Family: Drake Item No. 1992
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, and then
hanging the fixture from the ceiling.
start here
1992
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Assembly
06.01.13
1
2
3
4
5
1. To lamp fixture insert bulb through the open bottom and thread into socket.
2. To replace a glass panel (5), remove screw (1) located under the roof lip. Hold cage in
positioin when removing screws. After screws are removed the fixture cage (2) can be
removed.
3. Remove screw (3) holding the glass clip (4) in place.
4. Remove broken glass and slip new piece into place. Making sure bottom of glass fits
behind the tabs located in the bottom of the cage.
5. Replace glass clip (4) and thread screw (3) back into place to secure glass.
6. Replace cage (2) and secure with screws (1) removed earlier.
.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com