Hinkley Lighting OMNI FR47200PNI - Manual

FR47200PNI
OMNI
ASSEM BLY IN STRUCTIO NS
Assembly of this fixture will be accomplished by first attaching the mounting hardware
to the junction box, making all necessary wiring connections, mounting the fixture to
the wall and then installing the fix ture glass.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn off power supply during installation . If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
STEP 2
[DRAWING 1]
[DRAWING 2]
Bulb s: 60 W G-9
01.01.12
80 0.421 .3517 W WW.FREDRICKRA MOND.COM
4
1
2
3
1 To install glass, slip glass (4) over socket (3).
2 Slip spacer (2) o ver socket inside the glass (4).
3 Fixtu re can be lamped accordingly at this time.
4 Thread bulb shield (1) onto socket and tighten by hand until snug against
spacer (2) to secure glass.
A J
B
F
F1
C D
E
1 Prepare mounting strap (A) by threading threaded tube (C) into the center hole
of the mounting strap (A), approximately 1/4” - see Drawing 1.
2 Attach mounting strap (A) to junction box (J) using two short screws (C) provided.
3 Slip lock washer (F1) over nipple (C) and thread hex nut (F) onto threaded tube (C).
4 Hex nut (F) can be tightened against mounting strap (A) after adjusting threaded
tube (C) to proper mounting length.
6 Thread decorative knob (D) onto end of threaded tube (C) and tighten to secure fixture.
To mount fixture to wall slip center hole of backplate (E) over threaded tube (C) and
hold the fixture in position.
Note: Fixture should be lamped accordingly at this point before proceeding.
install
lamp
before
installing
glass