Hinkley Lighting CALISTOGA 2091 - Manual

assembly instructions
Item No. 2091
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first installling the
fixture glass, making all necessary electrical connections, and then mounting
fixture to pre-installed post.
start here
2091
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to complete installation of this fixture.
Drawing 2 - Glass Installation
Drawing 2 - Fixture Mounting
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 1.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post.
06.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
3
4
7
5
2
1
6
R
Glass installation Instructions - see Drawing 2.
1. First take glass (2) and slip small hole in top, over the socket (1), and hold glass in
position.
2. Slip socket spacer (3), lip side up, into glass and over socket (1), followed by socket
cover (4), threaded side up, and thread cover on to socket and tighten to secure glass.
3. Slip yoke assembly (5) over glass (2) making sure bottom lip of glass fits into ring (R).
4. Align yoke coupler (6) with threaded arm (7) and thread coupler onto arm and
tighten to secure yoke assembly (5).