Hinkley Lighting MARGEAUX 3586VS - Manual

assembly instructions
Item No. 3586
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
3586
*** The construction of this fixture will be accomplished by first assembling the main body,
hanging the fixture, and then installing the fixture glass.
2
3
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
6.1.12
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
1. To assemble main body (1), spread arms (A) until they are equally spaced 60 degrees
- see Drawing 1.
2. It is now necessary to determine the total length of rods (R) you will require to
hang your fixture at the desired height. Fixture is supplied with a 4”, 6”, 12” and
18” rod - see Drawing 2.
3. After determining the rod lengths needed, slip them along the wire and thread the
first rod into coupler (C). All subsequent rods (R) thread into each other.
4. Please refer to hanging instruction sheet (I.S. 19-81) provided to hang this fixture.
Then refer back to this sheet to install glass.
1. To install glass, remove socket ring (3) and spacer (4) from socket (2).
2. Slip glass (5) over socket (2), followed by spacer (4).
3. Thread socket ring (3) onto socket (2) to secure glass (5) using ring tool supplied.
NOTE: tighten socket ring till just snug.
4. Fixture can now be lamped accordingly.
12
1
2
3
4
5
R
A
socket
ring
tool
A A
A
A A
A
60º
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
C
6
9
10
7
8
1. To assemble bottom of fixture threaded tube (6) into decorative knob (7).
2. Slip threaded tube (6) with knob, through center hole in decorative cap (8).
3. Slip threaded tube (6) with knob and cap through center hole in bottom plate (9).
4. To complete assembly thread decorative cap (10) onto end of thread tube (6) and tighten.