Hinkley Lighting TRELLIS 1436 - Manual

- 1 -
____ Assembly Instructions ____
Item No. 1436
start here ---
1. Find a clear area in which you can work.
2. Unpack Fixture and glass from carton.
3. Carefully Review Instructions Prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, installing the glass, attaching the mounting strap to
the junction box, making all necessary electrical connections, and mounting
fixture to pier.
Drawing 3 – Fixture Mounting
1. To install glass (2) in cage assembly (1), slip bottom of glass panel into channel
(7) in the bottom of the cage - see Drawing 1.
2. Slip top of glass panel (2) under glass clip (6). - Note: cut gasket material
supplied to size and place between glass and clip.
3. Fold over glass clip (6) to secure glass in cage (1).
4. Prior to attaching the cage, slip candle sleeve (5) over sockets.
5. To attach completed cage (2) to roof assembly (3) line up holes in cage top and
roof.
6. Then thread ball knob stud (4) into roof to secure cage.
SAFETY WARNING: READ WIRING AND GROUNDING
INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.
TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW
WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR
LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Prepare gem strap (A) for mounting, by threading the two screws (B) provided
into the back of the gull wing bracket on gem strap (A) - see Drawing 2.
o Be sure that holes into which the screws are threaded match the spacing
_ of the Mounting holes (D) in the back plate (E) - see Drawings 2 and 3
2. Mount gem strap (A) to junction box (J) using two 1’’ long screws (C) provided.
Drawing 1 – Fixture Assembly
Drawing 2 – Strap Detail
1. Mount the fixture by slipping the holes (D) in the back plate (E) over the
screws (B) in the mounting strap (A) - see Drawing 3.
2. Hold fixture against wall and thread ball knobs (F) onto end of screw (B)
showing through the back plate.