Hinkley Lighting MARGEAUX 3587VS - Manual

assembly instructions
Item No. 3587
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
start he re
358
7
*** The construction of this fixture will be accomplished by first assembling the
main body, hanging the fixture, and then installing the fixture glass.
2
3
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INS TALL ATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
6.1.12
Drawing 1 - Fixtu re Assembly
1. To install glass, remove socket ring (3), spacer (4) from socket (2).
2. Slip glass (4) over socket (2) and hold in postion.
3. Slip spacer (4) over socket and thread on socket ring using socket ring tool provided.
4. Fixture can now be lamped accordingly.
1. It will be necessary to determine the total lenght of rods (R) you will require to
hang your fixture at the desired height. Fixture is supplied with 1 - 6” and 2 - 12” rods.
2. After determining the rod lenghts needed, slip the first rod along the wire and
thread into coupler (1). Continue to add rods as needed.
3. To finish installation of fixture please refer to instruction sheet (I.S. 19-81)
provided. Then refer back to this sheet to install glass.
R
REQUIRED
LENGTHS
R
R
5
1
2
3
4
socket
ring
tool
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com