Hinkley Lighting SORRENTO 1421AI - Manual

assembly instructions
Family: Sorrento Item No. 1421 AI
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To install glass, remove glass clips (1) by using a Philips screwdriver to remove screw
(2) from inside the top edge of the cage - see Drawings 2 and 1.
2. Tilt glass panels at an angle and insert them through the panel opening on the side of
the cage. Place bottom of glass behind the tab in the bottom of the cage.
3. After all panels are inserted replace the glass clips (1) removed earlier.
*** The construction of this fixture will be accomplished by first installing
fixture glass, making all neecessary electrical connections, mounting the fixture,
lamping the fixture and then assembling fixture.
start here
1421
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 1421 fixture is 100 watts per bulb.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Fixture Mounting
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
15
14
12
13
11
10
9
7
6
4
3 12
5
8
1. Fixture is mounted using 3 - 1/4-20 set screws.
2. Make all necessary electrical connections following wiring instructions below.
5 1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 3.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post.
6 1. Thread center stem (3) into top of harp (4) - see Drawing 1.
2. Slip interior glass globe (5) over harp and secure by using the small thumb screws
(6) provided.
3. Slip washer (7) over center stem (3).
4. Thread knurl nut (8) onto center stem (3) and hand-tighten.
5. Slip cap (9), checkring (10) (open side up) stem cover (11) over center stem (3),
making sure stem cover (11) fits into checkring (10).
6. Slip spider assembly (12) over center stem (3), making sure corner pins (13) fit into
corner holes in cage.
7. Thread knurl nut (14) onto center stem and tighten to secure spider assembly (11).
8. Thread top finial (15) onto fixture and hand-tighten.
12.10.08
1
2
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com