Hinkley Lighting ZELDA 3441PN - Manual

assembly instructions
item No. 3441
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections.
*** The construction of this fixture will be accomplished by first assembling the main body of
the fixture, installing the mounting bracket, making all necessary wiring connections, mount-
ing the fiture to the ceiling, and then installing the glass.
star t here
3441
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Mounting
Drawing 3 - Glass Installation
Drawing 1 - Strap Detail
6
J
B
A G
D
E
C
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting plate (B) - see
Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (D) - see Drawings 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip supply wires
through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (A) and hold in position - see Drawings 1
and
2. Thread ball knobs (E) onto end of screws (A) and tighten to secure fixture to ceiling.
6.1.12
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
1
2
7
5
3
4
6
8
9
10
13
shade
tab
11
12
1. To assemble main body of fixture, first thread hex nut (4) onto end of center stem (3)
apporximately 3/8”.
2. Slip cap (2) onto end of center stem (3) and over the hex nut (4) added previously.
3. Thread the 3/8” of exposed thread of center stem (3) above cap (2) into coupler (1) located in
the center of the socket assembly.
4.Thighten hex nut (4) against cap (2) to secure center stem (3).
5. Slip tube (5) over center stem (3) followed by cap (6).
6. Slip steel washer (7) followed by rubber washer (8) onto end of center stem (3). Fricition of
rubber washer will hold parts in place. Fixture is ready for installation.
1. After fixture body is installed, slip glass (9) onto center stem (3) and hold in position.
2. Slip rubber washer (10) and thread on ring nut (11) onto center stem (3) to secure glass.
3. Thread thread decorative ball (12) onto center stem (3) and tighten.
4. Slip shade (13) over glass and set tabs inside shade onto top of glass. Center shade on glass.