beautypg.com

Hinkley Lighting NEST FR41617ORB User Manual

Nest

background image

fR41617ORB

NEST

ASSEMBLY INSTRUCTIONS

Assembly of this fixture will be accomplished by first determining the length of stem

required, attaching the mounting strap to the junction box, making all necessary

electrical connections, hanging the fixture from the ceiling and then installing the

fixture glass.

SAFETY WARNING:

Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply off during installation. If new wiring

is required, consult a qualified electrician or local authorities for code requirements.

STEP 1

1

Determine the overall length you will need the assembled fixture to be.

2

Determine what stems will be needed to achieve the overall length you

require.(Additional stems are available and can be ordered. Ask your local

Fredrick Ramond representative or visit www.fredrickramond.com for

information.

3

Install stems by slipping them onto the supply wire of the fixture, threaded end up,

and threading them together.

STEP 2

1

Prepare mounting strap (a) by threading the two longest screws (b) into the back

of the mounting strap (a), making sure the holes into which the screws are
threaded match the spacing of holes (d) in the backplate (e)

- See Drawing 2.

2

Attach mounting strap (a) to junction box (j) using two screws (c).

3

Make electrical connections from supply wire to fixture lead wires. Refer to

instruction sheet [FRIS18] and follow all instructions to make all necessary

wiring connections. Then refer back to this sheet to continue installation of

this fixture.

4

To mount fixture, slip the two mounting screws (b) through the two mounting

holes (d) in the canopy (e).

5

While holding fixture in place, thread the two ball knobs (f) on to the end of the

mounting screws (b), and tighten.

STEP 3

1

Remove ring (1) and spacer (2) from socket (3) - See Drawing 2.

2

Slip glass (4) over socket and hold in position.

3

Slip spacer (2) and thread ring (1) onto socket (3) and tighten.

4

Fixture can now be lamped accordingly.

[DRAWING 1]

[DRAWING 2]

1

2

4

3

Bulbs:

100W MED.

Replacement Parts:

GLASS: R41617GL

j

a

c

e

d

f

b

6.11.09

800.421.3517 WWW.FREDRICKRAMOND.COM