beautypg.com

Hinkley Lighting TAHOE 2244RB User Manual

Start here, Assembly instructions

background image

assembly instructions

Family: Tahoe Item No. 2224 RB

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first assembling
the main body of the fixture, mounting the mounting strap to the junction
box, making all necessary electrical connections, mounting the fixture to the
wall, and then installing the glass.

start here

2244

1. Mount the fixture to the wall by slipping holes (E) in backplate (C), over screws (F) in
retainer plate (G) and securing with ball knobs (A) - see Drawing 1.

Drawing 1 - Fixture Mounting

1. To assemble main body, remove ball knobs (A) from backplate (C) and remove
retainer plate (G) - see Drawing 1.
2. Slip wire from junction box (B) through the 9/16” dia. access hole in the retainer plate (G).
3. Remove appropriate knock outs from the star pattern on the retainer plate (G) that
match the mounting hole location on your junction box (B).
4. Mount retainer plate (G) to the junction box (B) using the screws provided.
5. The top and bottom ends of the retainer plate have additional attachments points
that can be used. To attach the plate at these points use the wood screws (D) provided.

3

5

Drawing 2 - Glass Installation

A

C

E

A

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

B

D

D

F

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1

4

5

3

2

1. Remove ball knob (1) from under the roof edge - see Drawing 2.
2. Lift roof (2) off of fixture.
3. Slip glass (3) into position in the cage assembly (4).
4. Bend glass clips, that are located on the uprights (5) of the fixture, to secure glass
in the cage assembly (4).
5. Replace roof (2) and thread on ball knobs (1) to secure roof.

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com