Hinkley Lighting CHANNING 4220BN User Manual
Assembly instructions, Start here
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
assembly instructions
Item No. 4220
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first attaching the
mounting plate to the junction box, making all necessary electrical connections,
mounting backplate to mounting plate, and then attaching the glass.
start here
4220
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
1. Remove main mounting plate (A) from fixture back plate (B) by removing the four
flat head screws (C) - see Drawing 1.
2. Slide the wires from the junction box, through the large center hole, of mounting
plate (A), making sure curved slots (D) line up with the threaded holes (E) in the
junction box.
3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box.
A carpenters level can be used on the folded side of mounting plate (A) to check for
1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see
Drawing 1.
2. Attach the back plate (B) to mounting plate (A) with screws (C) removed earlier.
A
B
F
01.01.13
C
C
C
C
C
D
C
C
C
CE
Drawing 1 - Fixture Assembly
1
2
4
3
1. To install glass unthread socket ring (4) and remove socket spacer (3) from socket (1).
2. Slip glass (2) over socket.
3. Slip socket spacer (3) over socket and thread on socket ring (4) with socket tool
provided.
slip end of
socket tool
over ring