Hinkley Lighting MARGEAUX 3588VS - Manual

assembly instructions
Item No. 3588
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
3588
*** The construction of this fixture will be accomplished by first assembling the main body,
hanging the fixture, and then installing the fixture glass.
2
3
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
6.1.12
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
1. To assemble main body (1), spread arms (A) until they are equally spaced 45 degrees
- see Drawing 1.
2. Slip loop (L) along wire and thread onto tubing at top of the fixture, and tighten.
4. Please refer to hanging instruction sheet (I.S. 19) provided to hang this fixture.
Then refer back to this sheet to install glass.
1. To install glass, remove socket ring (3) and spacer (4) from socket (2).
2. Slip glass (5) over socket (2), followed by spacer (4).
3. Thread socket ring (3) onto socket (2) to secure glass (5) using ring tool supplied.
NOTE: tighten socket ring till just snug.
4. Fixture can now be lamped accordingly.
45 0
A
A A
A A
A A
A
1
2
3
4
5
A
socket
ring
tool
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
L
1. To assemble bottom of fixture threaded tube (6) into decorative knob (7).
2. Slip threaded tube (6) with knob, through center hole in decorative cap (8).
3. Slip threaded tube (6) with knob and cap through center hole in bottom plate (9).
4. To complete assembly thread decorative cap (10) onto end of thread tube (6) and tighten.
9
6
10
7
8