Hinkley Lighting BOLLA 4669OB-OP-LED User Manual
Start here, Assembly instructions

assembly instructions
Family: Bolla Item No. 4669
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the glass.
start here
4669
1. To assemble main body, attach arms (3) to fixture column assembly (4) using
lockwasher (2) and hex nut (1) - see Drawing 1.
2. Remove ball knob stud (14) from socket plate (I).
3. Take diffuser (13) and line up hole with holes in socket plate.
4. Thread ball knob stud (14) back into socket plate to secure diffuser.
1. Prior to installing glass, fixture can now be lamped.
2. To install glass, set glass (6) onto bottom assembly (7) - see Drawing 1.
3. Attach finial (8) to end of nipple (5).
4. Slip nipple (5) through center hole in assembly (7) and glass (6).
5. Slip rubber washer (10) and metal washer (11) onto nipple (5).
6. Thread nut (12) onto end of nipple (5) and tighten.
Note: Over tightening may cause damage to glass.
7. Line up the holes on the bottom assembly (7) arms (G) with the threaded stud (H)
extending out from end of arm (3).
8. Thread ball knob (9) onto end of stud (H).
Drawing 3 - Fixture Mounting
Drawing 2 - Strap Detail
B
(side view)
gull wing
bracket
B
1 2
3
4
Drawing 1 - Fixture Assembly
12
11
H
G
9
7
6
8
10
5
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to complete installation of this fixture.
1. Prepare gem strap (A) for mounting by threading two screws (B) provided into
back of gull wing bracket of gem strap (A) - see Drawing 2.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 2 and 3.
2. Mount gem strap (A) to junction box (J), using the two 1” screws (C).
5
10.26.10
14
13
I
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com