Hinkley Lighting REVERE 1181SN - Manual

assembly instructions
Family: Revere Item No. 1181 SN
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first making all necessary
electrical connections, and then mounting the fixture to pre-installed post.
start here
1181
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 1181 fixture is 60 watts per bulb.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 1 - Fixture Mounting
Drawing 2 - Lamping Instructions
3
5
4
2
1
1. Fixture is mounted using machine screws provided.
2. Make all necessary electrical connections following wiring instructions below.
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 1.
2. When fixture is slipped over pole make sure no wires are being pinched between the
top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into the bushing located on the post fitter.
4. Tighten screws to secure fixture to post.
5
1. To install glass and to lamp fixture, remove roof (1) from main body assembly (2),
by removing knob (3) from under roof lip
- see Drawing 2.
2. To install glass, bend up glass clip (4) and slip glass (5) into main body assembly (2).
3. Bend glass clip (4) back down to secure glass (5).
4. After all glass panels are installed, fixture can be lamped accordingly.
5. Replace roof (1) and thread on knobs (3).
5.18.10
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com