Hinkley Lighting CARLTON 4772SL - Manual

assembly instructions
Family: Carlton Item No. 4772
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading 1-5/8” nipple (C) into the center hole of
the mounting strap (A), up against hex nut approximately 1/4“ - see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two 1” screws (B) provided.
1. To mount fixture, slip center hole of backplate (E) over nipple (C) and hold fixture in
position - see Drawing 1.
2. Thread decorative knob (D) onto end of nipple (C) and tighten to secure fixture.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then completing assembly of fixture.
start here
4772
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 4772 fixture is 60 watts per bulb.
Drawing 1 - Fixture Mounting
Drawing 2 - Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
A J
B
C D
E
10.27.10
R4772CRY-E R4772CRY-C R4772CRY-B R4775CRY-A
REPLACEMENT PART #S
1. Slip candle sleeve (1) over socket (2) - see Drawing 2.
2. Attach crystal to fixture as indicated in Drawing 2. If replacement crystal is needed
please use part no. as listed when ordering.
1
2
CRY-B
CRY-A
CRY-A
CRY-E
CRY-C
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com