Hinkley Lighting OMNI FR47201PNI - Manual

fR47201PNI
OMNI
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished attaching the mounting strap to the
hanging the fixture from the ceiling and then installing the glass.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Prepare mounting strap (a) by threading the two longest screws (b) into the back
of the mounting strap (a), making sure the holes into which the screws are
threaded match the spacing of holes (d) in the backplate (e)
- See Drawing 2.
2 Attach mounting strap (a) to junction box (j) using two screws (c).
3 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
4 To mount fixture, slip the two mounting screws (b) through the two mounting
holes (d) in the backplate (e).
5 While holding fixture in place, thread the two ball knobs (f) on to the end of the
mounting screws (b), and tighten.
STEP 2
[DRAWING 1]
[DRAWING 2]
Bulbs: 60W G-9 Replacement Parts: SHADE: R47200GL , R47200BLSH
j
a
c
e
d
f
b
01.01.12
800.421.3517 WWW.FREDRICKRAMOND.COM
junction box, then making all necessary electrical connectioins,
1
2
To install glass slip glass (3) over socket (2)- see Drawing 2
Slip spacer (1) over socket (2).
Fixture can be lamped at this time with G-9 bulbs supplied.
Thread bulb shield (4) onto socket (2) and hand tighten only to secure glass.
Repeat for remaining pieces of glass.
3
4
3
4
1
2
5
install
lamp
before
installing
glass
Note: Fixture should be lamped accordingly at this point before proceeding.