Hinkley Lighting CELESTE FR42640SLF User Manual
Celeste

FR42640SLF
CELESTE
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first installing the mounting strap to
the junction box, making all necessary electrical connections, mounting the fixture to
the wall, and then installing the crystal and fixture glass.
SAFETY WARNING:
Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1
Prepare mounting strap (a) by threading the two longest mounting screws (b)
into the back of the mounting strap (a), making sure the holes into which the
screws are threaded match the spacing of holes (d) in the backplate (e) -
See
Drawing 1.
2
Attach mounting strap (a) to junction box (j) using two screws (c).
3
Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
4
To mount fixture, slip the two mounting screws (b) through the two mounting
holes (d) in the backplate (e).
5
While holding fixture in place, thread the two ball knobs (f) on to the end of the
mounting screws (b), and tighten.
STEP 2
1
Slip glass (3) over socket (s) - See Drawing 2.
3
Slip socket cover (4) over socket (s) making sure flat washer is facing down. Making
sure small tube on bottom of sleeve slips through bottom hole in glass.
4
Fixture can now be lamped accordingly.
[DRAWING 1]
[DRAWING 2]
j
Bulbs:
60W CAND.
Replacement Parts:
GLASS: FR42640gl, fR42640CRY
b a
c
e
d f
6.01.11
800.421.3517 WWW.FREDRICKRAMOND.COM
2
3
4
1
s
To install crystal (1) thread end into end of stem (2) until snug or in appropriate position.
2