Hinkley Lighting RICHMOND 1485 - Manual

Family: Richmond
I.S. 1480
glass installation
star t here
I.S. 1480
Drawing 1 - Glass Installation 1. To install the glass is first necessary to remove the roof from the
fixture. this is accomplished by remove the 2 phillip head screws (1),
located under the roof ledge -see Drawing 1.
1
2
1. First remove the glass clips (2) from the top of the cage, by
removing phillips head screws (3). Set screws and clips aside for use
later - see Drawing 2.
2. It is necessary to install glass panels in a particular order.
3. First install the large panel of glass (4) by slipping the glass into the
cage. Tilting panel back slightly and slipping the bottom edge (A)
into slot (B) located at the bottom of the cage - see Drawing 3.
4. Install glass clips (2) removed earlier to secure glass in cage.
5. Continue installing glass panels as outlined above, in this order.
Large panels first, small side panels, after all large panels are
installed.
6. Small side panels (5) are installed using the same method as the
large panels. Small panels are numbered 1 and 2. When looking at
front of the fixture panel 1 is installed on the left, 2 on the right.
6. After all the glass in installed. Fixture can be lamped accordingly
and the roof installed.
Drawing 2 - Glass Installation
Drawing 3 - Glass Installation
large flat panels
installed first
curved side
panel installed
last
match
number
to side
of cage
for side
panels
1
ROOF LEDGE
1
3
2
4
4
1480 / 1484 / 1485
01.01.12
1 2
left
right
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com