Hinkley Lighting BOLLA 2639 - Manual

assembly instructions
Family: Bolla Item No. 2639
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then assembling the main body of the fixture.
start here
Note: Maximum wattage for 2639 fixture is 40 watts per bulb.
Drawing 2 - Fixture Assembly
2639
1. Slip candle sleeve (1) over socket (H) located on cluster assembly (M) of main body
Drawing 2.
2. Thread tubing (2) into base of cluster assembly (M).
7.13.09
Drawing 1 - Fixture Mounting
E
B
F
D
C A J
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To mount fixture, slip the two mounting screws (B) through the two mounting holes
(D) in the backplate (E) - see Drawing 1.
2. While holding fixture in place, thread the two ball knobs (F) on to the end
of the mounting screws (B), and tighten.
1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the universal strap - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the back plate (E).
2. Attach mounting strap (A) to junction box (J) using two 1” screws (C) provided.
5
1
2
4
5
assembly (K) - see
1. To asssembly cage (3) slip glass (4) over tube (5) in bottom of cage. - see Drawing 2.
2. Slip rubber washer (6) over tube (5) followed by metal washer (7).
3. Thread hes nut (8) onto tube (5) to secure glass.
4. Place ring (9) on top of cage, algn holes and attach using the 3 screws (10).
5. To attach cage (3) to main body (K), slip tube (3) through center of tube (5) and
hold assembly in position.
6. Thread ball knob (11) onto end of tube (3) and tighten to secure glass to fixture.
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
6
8
7
9
10
11