Hinkley Lighting UNION 52370 - Manual

assembly instructions
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then installing the glass.
start here
Drawing 1 - Fixture Mounting
E
B
F
D
C A J
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To mount fixture, slip the two mounting screws (B) through the two mounting holes
(D) in the backplate (E) - see Drawing 1. NOTE: make sure holes () for mounting
glass support are at the bottom of the fixture - see Drawing 2.
2. While holding fixture in place, thread the two ball knobs (F) on to the end
of the mounting screws (B), and tighten.
1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the universal strap - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the back plate (E).
2. Attach mounting strap (A) to junction box (J) using two 1” screws (C) provided.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 44.653.5500 hinkleylighting.com
Item No. 52370
52370
Drawing 2 - Fixture Mounting
5
1. To install glass first it is necessary to attach the glass supports (2) to the backplate (E)
-see Drawing 2.
2. To install glass supports (2) first remove screw (1) from backplate (E).
3. To attach glass supports (2) align holes in support tab with threaded hold (G) in
backplate (E) and thread in screw (1) removed earlier.
NOTE: there is a left and right glass support. when installing support, hook (H) and
mounting tab of glass support face towards the outside edge of the fixture - see
Drawing 2.
4. After glass supports are attached slide in glass (3) from the top of the fixture, making
sure bottom edge of glass fits into hook (H) of glass support.
H
E
1
2
3
G