Specifications – Banner VS1 Series User Manual
Page 3
Specifications
Description
Feature
10 to 30V dc (10% maximum ripple) at less than 25 mA (exclusive of load)
Supply Voltage and
Current
Protected against reverse polarity and transient voltages
Supply Protection
Circuitry
SPST solid-state switch
Output Configuration
NPN (current sinking) or PNP (current sourcing), depending on model
Light operate (N.O.) or dark operate (N.C.), depending on model
50 mA maximum
OFF-state leakage current: < 1 microamp at 24V dc
Output Rating
ON-state saturation voltage: < 0.25V at 10 mA dc; < 0.5V at 50 mA dc
Protected against false pulse on power-up and continuous overload or short circuit of
outputs. Overload trip point
100 mA.
Output Protection
Circuitry
1 millisecond ON and OFF
Output Response Time
250 microseconds
Repeatability
Two LEDs: Green and Yellow
Green ON steady: sensor power ON
Indicators
Green flashing: output overload
Yellow ON steady: light is sensed
Yellow flashing: marginal excess gain (1-1.5x) in light condition
Black ABS/polycarbonate housing with clear acrylic lens
Construction
IP54; NEMA 3
Environmental Rating
2 m (6.5') attached cable: three #28 ga stranded conductors with PE insulation; PVC
outer cable jacket; or pigtail with 3-pin Pico-style quick-disconnect fitting. QD cables are
ordered separately.
Connections
Temperature: –20° to +55° C (–4° to +131° F)
Operating Conditions
Maximum Relative Humidity: 80% at 50° C (non-condensing)
M2 stainless steel mounting hardware included (see “Installation Notes”). Optional
mounting brackets are available (see
on page 6).
Application Notes
Certifications
3
Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N _56465_ rev. D
VS1 Series