Overview – Banner VS1 Series User Manual
Page 2
Overview
VS1 Series miniature self-contained sensors are designed for precision sensing in small areas previously accessible
only to remote or fiber optic models. Typical applications include mounting inside vibrating feeders and electronic
component handling equipment, where larger sensors will not fit.
The sensing energy of a convergent-mode sensor is concentrated at the specified focus point (see
1). Convergent-mode sensors are less sensitive to background reflections, compared with diffuse-mode sensors.
Contact the factory if background reflections are a problem.
Installation Notes
Figure 1. Sensor Mounting
Included with each sensor is a hardware packet containing two stainless
steel M2 x 0.4 x 16 mm Phillips pan-head machine screws, flat washers, lock
washers, and hex nuts. To mount the sensor, use the supplied flat washer
against the front surface of the sensor housing, between it and the screw
head. If mounting to one of the optional brackets, place the lock washer
against the back of the bracket, followed by the nut. If mounting directly to
a threaded hole, place the lock washer between the screw head and the flat
washer (see Figure 1).
For best results, mount the VS1 where it is protected from moisture, high
humidity and dirt.
1. Hex Nut (2)
2. Lock Washer (2)
3. Washer (2)
4. M2 x 0.4 x 16 mm Phillips
Pan-head Machine Screw (2)
WARNING . . . Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so
could lead to serious injury or death
This product does NOT include the self-checking redundant circuitry necessary to allow its use in personnel safety
applications. A sensor failure or malfunction can cause either an energized or denergized sensor output condition.
Consult your Banner Safety Products catalog for safety products that meet OSHA, ANSI and IEC standards for
personnel protection.
P/N _56465_ rev. D
Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
2
VS1 Series