Metrohm 850 Professional IC Anion MSM-HC - Gradient - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
850 Professional IC Anion MSM-HC HP-Gradient
￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 3
1.3 About the documentation ................................................... 3
1.3.1 Symbols and conventions ........................................................ 3
1.4 Safety instructions ................................................................ 4
1.4.1 General notes on safety ........................................................... 4
1.4.2 Electrical safety ........................................................................ 4
1.4.3 Tubing and capillary connections ............................................. 5
1.4.4 Flammable solvents and chemicals ........................................... 6
1.4.5 Recycling and disposal ............................................................. 6
2 Overview of the instrument 7
2.1 Front ...................................................................................... 7
2.2 Rear ........................................................................................ 9
3 Installation 12
3.1 About this chapter .............................................................. 12
3.2 Initial installation ................................................................ 12
3.3 Installation diagram ........................................................... 15
3.4 Setting up the instrument .................................................. 17
3.4.1 Packaging .............................................................................. 17
3.4.2 Checks .................................................................................. 17
3.4.3 Location ................................................................................ 17
3.5 Capillary connections in the IC system ............................. 17
3.6 Rear of the instrument ....................................................... 19
3.6.1 Rollers and handle ................................................................. 19
3.6.2 Positioning and connecting the detector ................................ 22
3.6.3 Transport locking screws ....................................................... 22
3.6.4 Leak sensor ........................................................................... 22
3.6.5 Drainage tubings ................................................................... 23
3.7 Capillary and cable feed-throughs .................................... 25
3.8 Eluent ................................................................................... 28
3.8.1 Connecting eluent bottle ....................................................... 28
3.9 Eluent degasser ................................................................. 32
3.10 High pressure pump ........................................................... 34
3.10.1
Capillary connections high pressure pump/purge valve ........... 34
3.10.2 Deaerating the high pressure pump ....................................... 36