Metrohm 850 Professional IC Anion MSM-HC - Gradient - Manual (Page 22)

3.1 About this chapter
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
850 Professional IC Anion MSM-HC HP-Gradient
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview
￭ a brief set of instructions for the initial installation of the 850 Professio-
nal IC Anion MSM-HC HP-Gradient (see Chapter 3.2, page 12). At
each step you will find cross-references to more detailed installation
instructions for individual components, should you require such aids.
￭ an installation diagram (see Chapter 3.3, page 15), showing a com-
pletely installed instrument.
￭ several chapters with detailed installation instructions for all compo-
nents, including those that are already installed at the time the instru-
ment is delivered.
3.2 Initial installation
Note
A large number of the capillary connections are already connected at
the time the instrument is delivered.
Installing 850 Professional IC Anion MSM-HC HP-Gradient
1 Setting up the instrument
See Chapter 3.4, Page 17.
2 Installations on the rear of the instrument
￭ Remove handle and rollers (see Chapter 3.6.1, page 19).
￭ Place the detector in the instrument and connect it (see manual
of the detector).
￭ Remove transport locking screws (see "Removing transport lock-
ing screws", page 22).
￭ Connect the leak sensor (see "Connecting the leak sensor ", page
22).
￭ Connect drainage tubings (see "Installing drainage tubings",
page 25).