Metrohm 876 Dosimat plus - Manual (Page 50)

6.1 Manual dosing (DOS)
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
42 ￭￭￭￭￭￭￭￭
876 Dosimat plus
Note
If a solution has been selected under Parameters, then the corre-
sponding titer and the concentration will be read out from the solution
data under System
▶ Solutions and used for calculations. If this is not
the case, then calculations will be made with the Default value 1.
Calculation status
Activating the calculation.
Selection on | off
Default value off
on
The settings for the calculation can be entered as soon as the calcula-
tion has been activated.
Result name
The result name will be shown in the result display and in the report.
Entry 12 characters
Decimal places
Number of decimal places used to display the result.
Input range 0 ... 5
Default value 2
Result unit
The result unit is displayed and saved together with the result.
Proceed as follows if you wish to delete a selected unit:
Delete the unit entered under User-defined. A blank entry will be gener-
ated in the selection list.
Selection % | /pc | L | g | g/L | mL | mg | mg/mL | mol |
mol/L | ppm | User-defined
Default value %
User-defined
A user-defined unit can be created. This will be added to the selection
list. The previous entry will be overwritten as soon as the new unit has
been defined.
Factor
Factor for the calculation formula.